![]() ![]() From System Properties, on the Computer Name tab, click Change.Note: If the domain or workgroup is joined, you must reestablish the domain or workgroup trust relationship after the restore and restart are complete. option on the Computer Name Change dialog box to manually add a domain suffix to the computer name that matches the system's original domain or workgroup suffix.Ĭhange the new system name to match the original system name by performing the following steps in the order listed: If the system was a domain controller, in a specific domain or workgroup, do not join the domain or workgroup. This basic installation is overwritten by the backed-up version, which restores your system configuration, application settings, and security settings. The computer name, Windows directory, and the file system (such as NTFS) must be the same as the previous Windows installation. This Windows installation is necessary to provide Backup Exec with a target to which it can restore the system. If you recover from an entire hard disk failure, use Windows setup to partition and format the new disk during installation. The same Service Pack and patches need to be applied after Windows is installed. Install the original version of Windows. ![]() To run a manual disaster recovery of a local Backup Exec server on a Windows computer See Microsoft's documentation for more information on BitLocker drive encryption.Īlways log on to Windows using the Administrator account or its equivalent during this procedure. Note: If you recover a Windows computer that has BitLocker encryption enabled, you must enable BitLocker encryption again after the restore. If you are performing an authoritative restore on a domain controller, DSRM credentials are needed.A storage device such as a tape drive, disk storage device, or a robotic library must be attached to the computer that you want to recover.You must retrieve it from that location to complete the recovery process. You should have exported the key to a secure location. For Backup Exec 15 and later, you must have the database encryption key that was used to encrypt the Backup Exec Database.A current full backup of the computer to be recovered and any subsequent incremental and differential backups.The following items are required for manual disaster recovery of a local system: If Simplified Disaster Recovery (SDR) is enabled for the computer, you should use SDR for disaster recovery. These steps are intended for manual disaster recovery only. See Manual disaster recovery of a remote Backup Exec server or remote agent on a Windows computer. Use a separate procedure for manual disaster recovery of a remote Windows computer. This procedure includes non-authoritative and authoritative restore of Active Directory for a domain controller. The agent-protected data should be restored after the system recovery is complete. If Backup Exec agents protect any of the data, refer to the section in the Backup Exec Administrator's Guide on how to restore the data that is protected by the agent before beginning disaster recovery. ![]() It also restores the data files, except for those that a Backup Exec agent protects, such as the Agent for Microsoft Exchange Server. This procedure restores the computer's operating system to a pre-disaster state. Solution Manual disaster recovery of a local Backup Exec server on a Windows computerįor automated disaster recovery process please review - Step by step guide for Simplified Disaster Recovery (SDR) with Backup Exec
0 Comments
Leave a Reply. |